MarCraft Specifications

MarCraft Custom HVAC Systems are built using the best technology available with our time-honored craftsmanship process, which results in the highest quality product possible. With an equipment life of 50+ years, the MarCraft System a customer purchases will be the only one needed during their career.

  • Design for any size requirement
  • 2″ – 4″ wall and roof panels for greater thermal and acoustical performance
  • Low leakage construction – less than 1% at 15″ w.c.
  • Access panels for removal of all coils and fan wheels
  • Wash-down systems for food manufacturing and other applications
  • Internal floor pan for water retention – no internal seals below floor pan lip to reduce any possible leaking of water into wall panel/insulation
  • Fan assembly run test and dynamic balance at the factory
  • Full structural steel base
  • In-house full piping capabilities
  • Stainless steel drain-pans in cooling coil sections to prevent rust and promote IAQ
  • Stainless steel cooling coil frames and baffles that extend coil life and promote IAQ
  • High-quality paint finish designed to withstand a minimum of 500-hour salt spray test
  • Well-known component manufacturers used for easy service and parts availability
  • Full custom penthouse capabilities
  • Thermal breaks
  • Special materials of construction and/or coatings
  • Chilled water/hot water/steam/DX piping
  • Indirect/Direct-Fired gas heating
  • Single point power connections
  • Full electrical distribution system
  • Evaporative Cooling systems
  • Explosion proof and anti-spark systems
  • Ultra-violet light systems
  • Variety of filtering options
  • Service vestibules
  • Multi-zone
  • Energy recovery
  • Dehumidification
  • Integral “Plug and Play” controls packages that can tie into building control system
  • Start-up/installation supervision
  • Unit design and engineering assistance
  • Large energy recovery
  • Stringent sound criteria
  • 2 x 2 fan array